Filter
Top Products
17
Inserting the Battery
First Steps
Removing the Battery
Turn the camera off and confirm that the power-on
lamp and monitor are off before removing the battery.
To eject the battery, open the battery-chamber/
memory card slot cover and slide the battery latch in
the direction shown 1. The battery can then be
removed by hand 2.
• Note that the battery may become hot during use;
observe due caution when removing the battery.
Turning On and Off the Camera
Remove the lens cap and press the power switch to
turn on the camera. The power-on lamp (green) will
light and the LCD monitor (or electronic viewfinder) will
turn on. The power-on lamp will turn off when the LCD
monitor turns on.
To turn off the camera, press the power switch again.
If the camera is turned off, hold down c to turn the
camera on in playback mode (A 28).
D Auto Power-Off in Shooting Mode (Standby Mode)
The LCD monitor will dim to reduce the drain on the battery if no operations are performed for
about five seconds. The LCD monitor will brighten when camera controls are used. At default
settings, the LCD monitor, or electronic viewfinder, will turn off altogether if no operations are
performed for about a minute during shooting and playback. The camera will turn off automatically
if no operations are performed for another three minutes (A 124).