188
8
Mode setup
If you use or to
select "YES" and press the
[OK] button, the displayed
image is erased and the
next image appears. To
cancel erasing, press the
(Erase) button or
select "NO" and press the
[OK] button. The CHECK
confirmation screen then
reappears.
● If you switch the camera off while an image is still displayed on the
CHECK screen image, the image is automatically saved.
6
Saving/erasing images right after shooting (CHECK)
P
O
W
E
R
/
M
O
D
E
D
I
A
L
P
A
/S
/M
O
F
F
6 6
6
• In Movie record mode or when you are using Auto Bracket to take shots,
you cannot take further pictures until you decide whether to save or erase
the current picture.
• If you select the CHECK option when TIFF quality mode is set, the quality
mode changes. Do not use the CHECK setting in TIFF mode. (Switch to a
high-quality mode with the same resolution.)
• You can still take pictures while you are using the CHECK option to check
shots. If you press the shutter button down halfway, the display on the mon-
itor changes and an image appears with focus lock applied. The CHECK
confirmation screen reappears 5 seconds after you switch to the photogra-
phy screen.
• While you are using the CHECK option to check shots, you can switch
between the "P" and "A/S/M" modes. If you switch between these ("P",
"A/S/M") modes and " ", all the pictures currently stored in the buffer
memory are automatically saved.
• If you take a picture while you are using the CHECK option, you cannot
select the following settings in the photography menu: "DRIVE", " ", " ",
"CARD SETUP", and "MODE SETUP".
• Never remove the card or replace the batteries while you are using the
CHECK option as the data in the buffer memory will be lost.
• The menu screens cannot be displayed while you are using the CHECK
option. Exit the CHECK screen before using the menus.
• The selected setting is retained until changed, even when the camera is
switched off.