Filter
Top Products
36
Getting Started
Turning the Power On in Playback Mode
1 Make sure the lens barrier is
closed.
2 Press the monitor button ( ).
• The camera turns on in
playback mode and the
monitor displays the last image
taken.
• “NO PICTURE” is displayed on
the monitor if no pictures have
been taken.
Any problems with the card
are indicated on the monitor
(p.19).
• The battery check mark blinks
when the batteries are running
low (p.20).
If the camera is left untouched for three minutes when using the
batteries, it automatically turns off. It is strongly recommended, however,
that you switch power off promptly when you are finished using the
camera.
When using new batteries, it may take longer for the camera to shut
down automatically depending on the type of batteries being used.
CAUTION
• Never open the card cover, remove the batteries or card, or disconnect the
AC adapter while the camera is in operation as this could result in damage
to the data stored on the card. When changing cards, be sure to turn the
power off before opening the card cover.
• Do not press on the monitor as this could leave a mark on the screen,
interfere with image display, or even crack the monitor.
HELP
• After turning the power on, the monitor may flash and display an image
after 0.5 to 2 seconds.This is not a malfunction.
1
2