Filter
Top Products
85
TROUBLE–
SHOOTING
Although the shutter button is pressed, the camera does not take a picture
Cause Remedy See
The camera power is off.
Previous picture is being
processed.
The card is full.
The battery power has run
out during shooting or card
writing.
A write protect seal is
attached to the card.
When the monitor can not display images
Cause Remedy See
The camera power is off.
No image has been saved
on the card in use.
When image protection, single-image erasure, all-image erasure or formatting is impossible
Cause Remedy See
A write protect seal is
attached to the card.
PROBLEMS
Open the lens barrier to trun the
camera on.
Release the shutter button and
wait until the green lamp stops
blinking.
Replace the card or erase
unwanted image frames. Or
download images to a PC and
then erase all image frames on
the card.
Replace the batteries with new
ones. (If the orange lamp is
blinking, wait until it stops.)
Insert new card or remove the
write protect seal.
p.14
p.22
p.12, 27
p.10
p.12, 13
Close the lens barrier, press the
button and turn the monitor
on.
Take pictures and then playback.
p.14
p.19
Remove the seal. Note that the
removed seal should not be
reused.
p.13