Filter
Top Products
50
Shoot the Picture
Full-press
1 Full-press the shutter release button. (Go
from half-press to full-press.)
Press the button gently. Pressing
forcefully or jerkily may cause the camera
to move, spoiling the picture.
• The camera issues a double beep to
indicate that it has successfully taken the
picture.
• The green lamp starts blinking rapidly, and
the processing gauge appears on the
monitor. These indications mean that
camera is busy writing data into the
SmartMedia card. After a while the green
lamp blinks more slowly, and then goes off.
2 Once the green lamp has slowed down (or
gone off), you can shoot again.
• If you try shooting while the lamp is blinking
rapidly, the camera will not take the shot.
Wait for the blink rate to slow down, and
then try again.
Monitor Processing gauge
Processing gauge
Before
shooting
Camera is writing
to card, but you
can shoot again
anyway.
Camera is very
busy writing to card.
You must wait.
Shutter
release button
Full-press