Filter
Top Products
74
Erasing a Selected Image
(“Erase Frame”)
Erasing images you don’t need increases the space available on the card.
You cannot erase an image if its image protection is set ON, or if the card itself is
protected by a write-protect seal. To erase a protected image, you must first switch the
protection off. To enable erasure from a write-protected card, you must remove the
card’s write-protect seal. (If you remove a write-protect seal, please discard it. Seals
should not be reused.)
1 Set the mode dial to PLAY ( ).
• The camera enters PLAY mode, and the
monitor displays the last image that you
took.
2 Use the arrow pad to navigate to an image
that you want to erase.
• You can select images using either full-size
display or index display (p.64).
3 Press the ERASE button ( ).
• The monitor displays a confirmation screen.
You can cancel by pressing the ERASE
button once again.
4 Press the OK button.
• The camera beeps once and erases the
image.
To erase all unprotected images at
once...
The camera’s “Erase Card” function erases all
unprotected images from the card in a single
operation. See page 151.
2
4
3
ESC
OK
ENTER
YES
NO
Monitor