Filter
Top Products
Troubleshooting
151
12
Appendix
The colors of pictures look unnatural.
Indoor lighting affected
the picture’s colors.
Set the white balance according to the
lighting.
P. 46
No white in the picture. Include something white in the picture, or
shoot using [#].
P. 38
The white balance
setting is wrong.
Adjust the white balance according to the
light source.
P. 46
Part of the picture is dark.
The lens was partly
blocked by your finger or
the strap.
Hold the camera correctly, keeping your
fingers and the strap away from the lens.
–
Pictures you have taken do not appear on the monitor.
The power is off. Set the mode switch to q, then press the
POWER switch to turn the camera on.
P. 10
The camera is in the
shooting mode.
Set the mode switch to q.P.10
There are no pictures in
the internal memory or
on the card.
[NO PICTURE] is displayed on the monitor.
Record pictures.
–
There is a problem with
the card.
See “Error messages”. P. 145
The camera is
connected to a TV.
The monitor does not function when the AV
cable is connected to the camera.
P. 76
Single-frame erase and all-frame erase cannot be performed.
The pictures are
protected.
Cancel the protection of the pictures. P. 77
No picture is displayed on the TV when connected to the camera.
The video output signal
is incorrect.
Set the video output signal according to the
region where used.
P. 77
The TV video signal
setting is incorrect.
Set the TV to the video input mode. –
The monitor is hard to see.
The brightness of the
monitor is not adjusted
properly.
Use [s] to adjust monitor brightness. P. 100
The monitor is exposed
to direct sunlight.
Block the sunlight with your hand. –
Possible cause Corrective action
Ref.
page