Filter
Top Products
Troubleshooting
152
12
Appendix
(When the camera is connected to a computer or printer
(When using i-compatible devices
Possible cause Corrective action
Ref.
page
The printer fails to connect.
PC was selected on the
monitor after connecting
the camera to the printer
with the USB cable.
Remove the USB cable, and start again from
Step 1 of “Printing pictures”.
P. 117
The printer does not
support PictBridge.
Refer to the printer’s instruction manual or
contact the manufacturer.
–
The camera is not recognized by the computer.
The computer failed to
recognize the camera.
Disconnect the USB cable from the cradle,
and connect it again.
P. 135
The USB driver has not
been installed.
Install OLYMPUS Master. P. 130
Possible cause Corrective action
Ref.
page
Pictures from the camera cannot be saved in the storage unit.
The storage unit is not
turned on.
Turn the storage unit on. P. 105
The mode switch on the
storage unit is set to
[PC].
To save pictures from the camera directly to
the unit, set to [_DOCK].
P. 105
The [STORE] setting is
set to [NOT STORE].
Set it to [STORE]. P. 113
The printer fails to print.
The printer is not turned
on.
Turn the printer on. P. 110
The printer is connected
to the storage unit (hard
disk or DVD) with the
USB cable.
Use the optional Dock&Done cable to
connect the printer to the storage unit (hard
disk or DVD).
P. 110