Filter
Top Products
16 En
En
J SETTING THE DATE AND TIME
1
Open the lens barrier fully.
• The lens extends and the monitor turns on.
2
Press .
• The top menu is displayed.
3
Press on the arrow pad to select MODE MENU.
4
Press to select the SETUP tab, then press .
5
Press to select , then press .
• The green frame moves to the selected item.
6
Press to select one of the following date formats: Y-
M-D (Year/Month/Day), M-D-Y (Month/Day/Year), D-M-Y
(Day/Month/Year). Then press .
• Move to the year setting.
• The following steps show the procedure used when the date and time
settings are set to Y-M-D.
7
Press to set the year, then press to move to the
month setting.
• To move back to the previous setting, press .
•
The first two digits of the year are fixed.
8
Repeat this procedure until the date and time are
completely set.
• The camera only displays the time in 24-hour time system (“2 p.m.”
would be “14:00”).
9
Press .
• For a more accurate setting, press when the time hits 00
seconds. The clock starts when you press the button.
10
Close the lens barrier to turn the camera off
• The date and time settings will be canceled if the camera is left
without batteries for approximately one day.
Note
basic_e_opx_6.fm Page 16 Thursday, December 12, 2002 10:44 AM