Filter
Top Products
61
EN
61
Make the settings for the functions while referring to “Using the Menu” (p. 3).
To play back camera images on a TV
1 Connect the TV and camera.
Connect to the TV video
input jack (yellow) and
audio input jack (white).
Connector cover
AV cable (supplied)
Multi-connector
2 Use the camera to select the same video signal system as the one of connected TV ([NTSC]/
[PAL]).
3 Turn on the TV, and change “INPUT” to “VIDEO (an input jack connected to the camera)”.
For details on changing the input source of the TV, refer to the TV’s instruction manual.
4 Set the mode dial to q, and use 789: to select the image for playback.
Depending on the TV’s settings, the displayed images and information may be cropped.
Displaying grid lines [FRAME ASSIST]
x SETUP X FRAME ASSIST
Submenu 2 Application
OFF (No grid
lines displayed)/
w/x
Grid lines (square/diagonal) are
displayed on the LCD monitor as
guides for composing the image.
“Changing the shooting information
display” (p. 25)
Displaying the brightness distribution
[
u
]
x SETUP X u
Submenu 2 Application
OFF No histogram is displayed.
ON
A histogram (a brightness
distribution as a guide for
determining the exposure) is
displayed.
DIRECT
White-out areas are displayed
as red, and black-out areas are
displayed as blue directly on the
image.
“Changing the shooting information
display” (p. 25), “Changing the image
information display” (p. 29)
Adjust the settings for the functions while referring to “Using the Menu” (p. 3).
book_d4374_en.indb 61book_d4374_en.indb 61 18/07/2008 13:39:2418/07/2008 13:39:24