Filter
Top Products
105
7
Chapter 7 Menu description tables
(continued)
The underlining in the variable range column indicates the setting in the preset
mode.
7-2-7 DOWNCON SETTING
H.DTL LEVEL 00
:
08
:
31
For setting the horizontal detail correction
level for the down converter output signals.
V.DTL LEVEL 00
:
04
:
31
For setting the vertical detail correction level
for the down converter output signals.
DTL CORING 00
01
:
15
For setting the noise elimination level of the
details.
H.DTL FREQ. 1
:
3
:
5
For selecting the horizontal detail
frequencies.
1: 2.5 MHz 4: 4 MHz
2: 3 MHz 5: 4.5 MHz
3: 3.5 MHz
CUFR
CUFR
CUFR
CUFR
2DLPF ON
OFF
For setting the 2-D low path filter reducing
cross colors.
ON: Cross colors are reduced.
OFF: Cross colors are not reduced.
CUFR
SET UP
For AJ-HDX900E
For AJ-HDX900P
0%
7.5%
For setting the setup level for the down
converter output signals.
<Note>
When the system frequency is set to 50 Hz,
the setup level will be 0%.
CUFR
CUFR
CUFR
Item
Variable
range
Remarks
DOWNCON MODE SQUEEZ
LT-BOX
S-CROP
For setting the mode of the down converter
output signals.
DETAIL ON
OFF
For setting the detail function for the down
converter output signals ON/OFF.
The down converter output signals contain
detailed components that are set during HD
signal processing. In this setting, these
signals overlap the detailed components
dedicated to the down converter outputs.
Even if this setting is turned off, it is
impossible to turn off the detailed
components set during HD signal
processing.
Item
Variable
range
Remarks
GENLOCK INT
EXT
For setting the standard signals for
executing the GENLOCK.
INT: For synchronizing to the standard
signal within the unit regardless of the
signals that are input in the GENLOCK
IN connector.
EXT: For synchronizing to the standard
signals that are input in the GENLOCK
IN connector.
H PHASE COARSE –100
:
+000
:
+100
For making coarse adjustment for aligning
phases of the horizontal synchronization, for
executing the GENLOCK.
GL PHASE HD SDI
COMPOSIT
For selecting the output signals that lock
phases to the signals that are input in the
GENLOCK IN connector.
HD SDI:
For locking the HD SDI signals to the
GENLOCK input.
For the down converter output signals,
the start position of the video delays by
about 90 lines.
COMPOSIT:
For locking the down converter output
signals to the GENLOCK input.
For the HD SDI output signals, the start
position of the video gains by about 90
lines.
H PHASE FINE –100
:
+000
:
+100
For making fine adjustment for aligning
phases of the horizontal synchronization, for
executing the GENLOCK.
7-2-8 GENLOCK
CUFR
CUFR