Filter
Top Products
13
VQT1S36
Before Use
Attach the lens cap.
• Detach the lens cap before turning on the
camera in the recording mode.
• Do not hang or swing around this unit with
the lens cap string attached.
• Be careful not to lose the lens cap.
∫ Strap
•
We recommend attaching the strap when using the camera to prevent it from dropping.
Pass the strap through the hole at the strap
eyelet.
Pass the strap through the
stopper and fasten the strap.
A Pull the strap 2 cm or more.
• Attach the strap to the other side of the camera being
careful not to twist it.
• Check that the strap is firmly attached to the camera.
• Attach the strap so that the “LUMIX” LOGO is on the outside.
Attaching the Lens Hood
In bright sunlight or backlight, the lens hood will minimize lens flare and ghosting. The lens
hood cuts off excess lighting and improves the picture quality.
•
Check that the camera is turned off.
• Close the flash.
Securely attach the hood adaptor
so that it is all the way into the
lens barrel.
• Do not tighten the hood adaptor too much.
• When attaching the hood adaptor, take
extended care not to cross-thread.
When removing it, do not squeeze it as it
will not unscrew freely.
DMC-FZ28P_PC.book 13 ページ ２００８年７月２日 水曜日 午後１１時１４分