Panasonic DMC FZ 28 Digital Camera User Manual


 
VQT1S36
18
Preparation
Battery: Insert it fully being careful
about the direction you insert it. Pull
the lever A in the direction of the
arrow to remove the battery.
Card: Push it fully until it clicks
being careful about the direction
you insert it. To remove the card,
push the card until it clicks, then
pull the card out upright.
B: Do not touch the connection terminals of
the card.
The card may be damaged if it is not fully
inserted.
1:Close the card/battery door.
2:Slide the card/battery door to the end
and then close it firmly.
If the card/battery door cannot be completely
closed, remove the card, check its direction and
then insert it again.
Note
Remove the battery after use.
Do not remove the battery while the power is on as the settings on the camera may not be
stored properly.
The supplied battery is designed only for the camera. Do not use it with any other equipment.
Before removing the card or battery, turn the camera off, and wait until the power lamp has
gone off completely.
(Otherwise, this unit may no longer operate normally and the card itself may be damaged or the
recorded pictures may be lost.)
About the Built-in Memory/the Card
The following operations can be performed using this unit.
When a card has not been inserted: Pictures can be recorded in
the built-in memory and played back.
When a card has been inserted: Pictures can be recorded on the
card and played back.
When using the built-in memory
k
>ð (access indication
¢
)
When using the card
(access indication
¢
)
¢ The access indication lights red when pictures are being recorded on the built-in memory (or
the card).
B
DMC-FZ28P_PC.book 18 ページ 2008年7月2日 水曜日 午後11時14分