Filter
Top Products
10 VQT2M98 VQT2M98 11
I
nserting and removing the card (optional)/
the battery
Turn the camera off and slide
the release lever to [OPEN]
before opening the lid
[OPEN] [LOCK]
Release lever
Completely insert battery
and card
(both click into place)
Close lid
Slide to the [LOCK] position.
■
To remove
• To remove battery: • To remove card:
move lever in
direction of arrow.
Lever
press down in
center.
●
Always use genuine Panasonic batteries.
●
If you use other batteries, we cannot guarantee the quality of this
product.
●
Remove battery from camera after use.
• Store the battery in battery carrying case (supplied).
●
To remove the card or battery, turn the camera off and wait until
the LCD monitor display is completely blank. (Failure to wait may
cause the camera to malfunction and may damage the card or recorded data.)
●
Keep the Memory Card out of reach of children to prevent swallowing.
●
The unusable battery should be discarded in accordance with battery recycling laws.
Call the RBRC hotline at 1-800-822-8837 for information.
Charged battery (check orientation)
Card (check orientation: terminals face
LCD)
Do not
touch
terminal
Remaining battery and memory capacity
Pictures remaining (→92)
Displayed when no card inserted (pictures will be saved to built-in memory)
Remaining battery (only when using battery)
(flashes red)
If the battery mark flashes red, recharge or replace battery. (→8)
When in operation
(Card) or (Built-in memory) are illuminated red.
This means that an operation is in progress, such as the recording, reading, deleting,
or formatting of pictures. Do not turn off the power or remove the battery, card, or AC
adaptor (optional) (this may cause damage to or loss of data).
Do not subject the camera to vibrations, impact, or static electricity. Should any of these
cause camera operation to be terminated, attempt to perform the operation again.
Picture save destination (cards and built-in memory)
Pictures will be saved to a card if one is inserted, or to the built-in memory if not.
■
Built-in memory (approx. 40 MB)
●
Pictures may be copied between cards and the built-in memory (→73).
●
The access time for the built-in memory may be longer than the access time for a card.
●
[QVGA] in [REC QUALITY] only can be available to record motion pictures in the built-in memory.
■
Compatible memory cards (optional)
The following SD standard-based cards (Panasonic brand recommended)
Type of Card Capacity Notes
SD memory
cards
8 MB – 2 GB • Can be used with devices compatible with
the respective formats.
• Before using SDXC memory cards, check
that your computer and other devices
support this type of card.
http://panasonic.net/avc/sdcard/information/
SDXC.html
• Cards in capacities not listed at left are not
supported.
SDHC memory
cards
4 GB – 32 GB
SDXC memory
cards
48 GB – 64 GB
●
Please reformat the card with this camera if it has already been formatted with a
computer or another device. (→21)
●
If the write-protect switch is set to ‘LOCK’, the card cannot be used to record or delete
pictures, and it cannot be formatted.
●
It is recommended that you copy important pictures to your computer (as
electromagnetic waves, static electricity, or faults may cause data to be damaged).
●
Latest information:
http://panasonic.jp/support/global/cs/dsc/ (This Site is English only.)
Switch (LOCK)