Filter
Top Products
20
Attaching the Strap/Attaching the Lens
Cap
When the camera is switched off or used in
playback mode, protect the lens surface by
attaching the supplied lens cap.
1
Pass the end of the string through the
lens cap eyelet.
2
Pass
the knotted end of the string
through the other end of the string
and pull it firmly.
3
Pass the strap through the strap
hole.
4
Pass
the end of the strap through the
small loop at the knotted end of the
string.
5
Fold the tip of the strap, run it
through the strap length adjuster,
and pull it.
• Pull it out more than 0.07 feet (2 cm)
1
from
the strap length adjuster so that it cannot slip
off.
• Remove the lens cap before turning the
camera on. (P18)