Filter
Top Products
-38-
Default: OFF
AUTO1: The camera selects black and white mode
if the picture is dark, or color mode if the pic-
ture is bright enough.
Note: Color picture switches to black-and-
white picture and vice versa in approxi-
mately 1 or 2 minutes after recognition of
illuminance.
AUTO2: Applying AUTO1 may cause malfunction
when using a source of near-infrared light at
night because the illuminance changes signifi-
cantly when switching between the color pic-
ture and the black-and-white picture. But
AUTO2 allows the unit to prevent malfunction
because it simply recognizes a source of light.
Note: Because a source of light is simply rec-
ognized based on the information from
CCD image pickup element, an object
sometimes can not be recognized suc-
cessfully when the object is always mov-
ing or the object and its background have
the same color.
When you apply this mode, AUTO2, the
wavelength of the light source should be
800 nm or more.
ON: Black and white mode is selected.
OFF: Color mode is selected.
** SPECIAL **
UP SIDE DOWN OFF
CHROMA GAIN ....I....
AP GAIN ....I....
PEDESTAL ....I....
HUE ....I....
- +
BW OFF
BURST (BW) ON
CAMERA RESET PUSH SW
RET END
10.7 BURST (BW)
1. Move the cursor to the BURST (BW) parameter.
2. Select ON or OFF using or .
Default: ON
ON: The burst signal is supplied along with the
black and white composite video signal.
OFF: The burst signal is not output.
Note: We recommend that you usually select
ON.
** SPECIAL **
UP SIDE DOWN OFF
CHROMA GAIN ....I....
AP GAIN ....I....
PEDESTAL ....I....
HUE ....I....
- +
BW OFF
BURST (BW) ON
CAMERA RESET PUSH SW
RET END