Filter
Top Products
24
Before starting the connection, make sure that the power of the devices to be connected such
as the camera and a PC are off or the power cords of the devices are disconnected.
Before starting the connection, prepare the required devices and cables.
z Connect an RCA plug to the monitor out con-
nector provided on the rear only for adjust-
ment of the angular field of view on the video
monitor.
Important:
• The monitor out connector is provided only
for checking the adjustment of the angular
field of view on the video monitor when
installing the camera or when servicing.
It is not provided for recording/ monitoring use.
Connection
FOCUS
ASSIST
LINK
POWER
AUDIO OUT MIC IN
EXT I/O
1 2 3 4
C B A
MONITOR OUT
SD
CARD
12V IN
24V IN
ACT
100BASE-T/
100BASE-TX
Connect to the video
monitor, etc.
FOCUS
ASSIST
LINK
POWER
AUDIO OUT MIC IN
EXT I/O
1 2 3 4
C B A
MONITOR OUT
SD
CARD
12V IN
24V IN
ACT
100BASE-T/
100BASE-TX
!
@
C
B
A
Power cord plug (provided)
Approx. 3 mm - 7 mm
To power source
(24 V AC/12 V DC)
x Connect to the power source.
Important:
• 24V AC/12 V DC power supply shall be insulated
against 220 V - 240 V AC.
• When connecting to 24 V AC/12 V DC power
source
q Loosen the screw of the provided power cord
plug.
w Insert the power cord of an optional AC adapter
to the power cord plug.
When using 24 V AC/12 V DC power supply,
remove 3 mm - 7 mm of the outer jacket of the
power cord from a power supply and twist the
core of the power cord to prevent a short circuit.
Specification of cord (wire): AWG #22 - #28 sin-
gle core, twisted
<Ratings>
AC24 V DC12 V
AN @(GND)
B GND NC
CL !
* Make sure that the power cord plug
is inserted to the power cord termi-
nal firmly.
* Make sure that the exposed core wires are
completely hidden after inserting the power
cord.
e Tighten the screws to fix the inserted power
cord.
r Connect the power cord plug to the 24 V
AC/12 V DC power cord terminal on the rear
of the camera.
Caution:
ONLY CONNECT THIS TO 24 V AC OR 12 V DC CLASS 2 POWER SUPPLY.