Filter
Top Products
Page 3
Installation Instructions CC3320 and CC4620 Cameras
PRODUCT SAFETY
Ensure installation and servicing is carried out by qualified personnel.
Isolate from the supply circuit before any servicing.
Installation method and materials must be capable of supporting four times the total
weight of the unit.
Power supply cords must be connected as defined in national electrical codes of
practice for Class 1 earth protected equipment.
Low voltage cameras must be connected as defined in national electrical codes of
practice for Class 2 protection of double or reinforced insulation.
Safety critical components must only be replaced with recommended parts.
The maximum load on the rear (auto-iris) connector must not exceed 50 mA.
The maximum load on the direct drive connector must not exceed 25 mA.
REGULATORY NOTICES
Federal Communications Commission Part 15 - Digital devices
This Device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions:
(1)this device may not cause harmful interference, and
(2)this device must accept any interference that may cause undesired operation.
CERTIFICATIONS
This product meets the requirements of the following standards:
Electromagnetic Compatibility
EN55022: 1995 limits and methods of measurement of radio disturbance characteristics of information
technology
EN50082-1: 1992 Generic immunity standard
Comprising:
IEC 1000-4-2:1995 Electrostatic discharge
IEC 1000-4-3:1995 Radiated electromagnetic fields
IEC 1000-4-6: Immunity to conducted disturbances, induced by radio-frequency fields
IEC 1000-4-4:1995 Fast transient bursts
Safety
EN 60950: 1992 Safety of information technology equipment, including electrical business equipment
DECLARATIONS
The manufacturer declares that the equipment supplied with this manual is compliant with the EMC
directive 89/336 EEC and the low voltage directive 73/23 EEC and CE marked accordingly.