Pelco C2410M-H Camera Lens User Manual


 
Pelco Manual C2410M-H (10/05) [ 5 ]
8.32 X .750 SCREW
(SUPPLIED)
8.32 X .375 SCREW
(SUPPLIED)
WALL OR
CEILING
ADAPTER PLAT
E
BACK BOX
4S DEEP
ELECTRICAL
BOX
01063
CEILING TILE
BACK BOX
ADAPTER PLATE
8-32 X 1.25
MOUNTING
HARDWARE
(SUPPLIED)
01062
Mounting to 4S Deep Electrical Box
1. Attach adapter plate to the 4S box
with the two 8-32 x .750-inch
screws.
2. Connect the video cable.
3. Connect the power wires.
For 12 VDC, connect the
24 VAC/12 VDC (red) and GND
(black) wires to input power.
For 24 VAC, connect the
24 VAC/12 VDC (red) and
24 VAC (blue) wires to input power.
4. Attach the back box to the adapter plate
with the four 8-32 x .375-inch screws.
Mounting to Ceiling Tile
1. Remove the ceiling tile.
2. Using the adapter plate as a template, cut
a hole 3.5 inches (9 cm) in diameter in the
ceiling tile for the back box. Punch four
screw holes in the ceiling tile.
3. Attach the back box to the ceiling tile and adapter plate with the four 8-32 x 1.25-inch screws (see
diagram).
4. Replace the ceiling tile.
5. Remove an adjacent ceiling tile and connect the video cable.
6. Connect the power wires.
For 12 VDC, connect the 24 VAC/12 VDC (red) and GND (black) wires to input power.
For 24 VAC, connect the 24 VAC/12 VDC (red) and 24 VAC (blue) wires to input power.
2 Install Camera
1. Some indoor installations do not require a
heater. If the installation does not require a
heater, remove the heater board from the
camera assembly. To remove the heater
apply pressure and press on the corner of
the board.
Heater elements could be hot! When camera power is on, use caution when
adjusting the camera. This applies to all models.
CAUTION
HEATE
R
BOARD
1092