Filter
Top Products
LINE SYNC PHASE - The cursor moves to a numeric value. Move the joystick up or down
to change the value. Press the Iris Open button to select the choice. The value represents the
phase angle in tenths of a degree between 0 degrees and 359 degrees. For example, 900 is
90 degrees, 1200 is 120 degrees, and 2400 is 240 degrees. Press the Iris Open button on
your keyboard to select your choice. The Line Sync setting will change to ON. The camera
may reset or the picture on your monitor may wiggle when you change the phase angle. If the
camera resets, it will only affect the line synchronization. It will not change any other camera
parameters, such as auto focus or auto iris. Press the Iris Close button if you do not want to
change the setting.
PARK TIME MINUTES
Main Menu Other Menu
<Camera>
<Line Sync>
<Power Up>
<Aux>
<Alarms, Zone Blank>
<Other>
EXIT
Auto flip On
Proportional pan On
Limit stops Off
Park time minutes 0
Scan speed deg/s 25
Pattern length 1.5 min
Exit
This feature causes the dome to park at preset 1 after a programmed number of minutes of
control inactivity. The time can be set from 1 minute to 720 minutes (12 hours), or it can be set
to zero, which disables this feature.
To change the park time:
1. Program preset 95 (28). The main menu appears.
2. Position the cursor (>) beside Other.
3. Press the Iris Open button to enter the Other menu.
4. Position the cursor (>) beside Park Time Minutes.
5. Press the Iris Open button. The cursor moves to the right, beside the current park time.
6. Move the joystick up or down to change the park time.
7. SELECT - Press the Iris Open button on your keyboard to select your choice.
CANCEL - Press the Iris Close button if you do not want to change the setting.
NOTE:
Preset 1 must be
programmed for the dome to
park.
PATTERN LENGTH
Main Menu Other Menu
<Camera>
<Line Sync>
<Power Up>
<Aux>
<Alarms, Zone Blank>
<Other>
EXIT
Auto flip On
Proportional pan On
Limit stops Off
Park time minutes 0
Scan speed deg/s 25
Pattern length 1.5 min
Exit
The Spectra II dome can do the following:
One full pattern - 1.5, 3, or 6 minutes long.
or
Two half patterns - .75, 1.5, or 3 minutes long.
This pattern can consist of any standard pan and tilt or lens command. Presets, flip, and
turbo are not allowed in a pattern. Zone scan can be enabled while running a pattern.
To set the pattern length:
1. Program preset 95 (28). The main menu appears.
2. Position the cursor (>) beside Other.
3. Press the Iris Open button to enter the menu entitled Other.
4. Position the cursor (>) beside Pattern Length.
5. Press the Iris Open button. The cursor moves to the right, beside the number of
minutes (1.5, 3, or 6).
6. Move the joystick up or down to toggle through the number of minutes (1.5, 3, or 6).
7. SELECT - Press the Iris Open button on your keyboard to select your choice.
CANCEL - Press the Iris Close button if you do not want to change the setting.
CAUTION:
If the
length is changed,
all patterns that
were stored are erased.
Pelco Manual C2423M (5/00) 19