Filter
Top Products
C2443M-C (1/04) 13
DISPLAY SETUP
Display setup allows you to program how labels are displayed on the monitor. The following
labels are available:
PRESET LABEL - Identifies preset.
ZONE LABEL - Identifies zone.
ZOOM RATIO - Identifies the amount of magnification.
AZIMUTH
1
/ELEVATION
2
- Amount of pan from 0° and the amount of tilt from 0° horizontal.
DIRECTION - Displays compass direction.
ALARM MESSAGE - Displays activated alarm.
A preset label is displayed when a preset is called. A zone label is displayed when the system
moves into a zone. The zoom ratio label is displayed when zoom is activated. Azimuth/elevation
and direction labels are displayed when pan/tilt is activated. An alarm message appears on the
monitor when an alarm occurs.
The following settings are available for each label:
OFF - Label is not displayed when activated.
CONSTANT - The label is continually displayed when activated.
2 SECONDS - The label is displayed for 2 seconds after activation.
5 SECONDS - The label is displayed for 5 seconds after activation.
10 SECONDS - The label is displayed for 10 seconds after activation.
1
Azimuth is the pan angle from 0° to 359°.
2
Elevation is the tilt position from 0° (horizon) to -90°.
BACK
EXIT
PRESET LABEL 2 (SECS)
ZONE LABEL 2 (SECS)
ZOOM 2 (SECS)
AZIMUTH/ELEVATION 2 (SECS)
DIRECTION OFF
ALARM MESSAGE 2 (SECS)
<LABEL POSITIONS>
RESTORE FACTORY DEFAULTS
DISPLAY SETUP
(See page 9)
Quick Programming Guide
EXIT
SPECTRA III
LANGUAGE ENGLISH
<SYSTEM INFORMATION>
<DISPLAY SETUP>
<DOME SETTINGS>
ACK ALERT*
RESET CAMERA
CYCLE CAMERA POWER
REBOOT SYSTEM
* This setting only applies to
Pressurized Spectra III SE dome
systems with software version
1.25 or higher.