Filter
Top Products
20 C2443M-C (1/04)
BACKLIGHT COMPENSATION (BLC)
If a bright backlight is present, the subjects in the picture may appear dark or as a silhouette.
Backlight compensation enhances objects in the center of the picture. The dome uses the center
of the picture to adjust the iris. If there is a bright light source outside of this area, it will wash
out to white. The camera will adjust the iris so that the object in the sensitive area is properly
exposed.
There are two backlight compensation settings:
ON - Backlight compensation is activated.
OFF (default) - Backlight compensation is not activated.
NOTE: If backlight compensation is ON, decrease the Auto Iris setting. Refer to the
Auto Iris
section.
VIDEO LEVEL
Set the video output to one of the following:
NORMAL - 1.0 volt peak-to-peak
HIGH (default setting) - 1.2 volt peak-to-peak to compensate for losses in video cable.
BACK
EXIT
ADVANCED SETTINGS
SHUTTER SPEED AUTO
AGC LIMIT 27
AUTO IRIS AUTO
AUTO IRIS LEVEL 66
AUTO IRIS PEAK 8
AUTO SHARPNESS ON
SHARPNESS LEVEL 26
BACKLIGHT COMP OFF
VIDEO LEVEL HIGH
BACK
EXIT
TYPE OF LIGHTING OUTDOOR
AUTO FOCUS ON
ZOOM LIMIT X176
ZOOM SPEED MEDIUM
LOW LIGHT LIMIT 2
<ADVANCED SETTINGS>
CAMERA
EXIT
SPECTRA III
LANGUAGE ENGLISH
<SYSTEM INFORMATION>
<DISPLAY SETUP>
<DOME SETTINGS>
ACK ALERT*
RESET CAMERA
CYCLE CAMERA POWER
REBOOT SYSTEM
BACK
EXIT
<CAMERA>
<MOTION>
<POWER UP>
<LINE SYNC>
<PRESETS>
<PATTERNS>
<ZONES>
<WINDOW BLANKING>
<ALARMS>
<AUX>
<ALERT>*
<CLEAR>
<PASSWORD>
DOME SETTINGS
* This setting only applies to
Pressurized Spectra III SE dome
systems with software version
1.25 or higher.