Filter
Top Products
30 C2443M-C (1/04)
<Patterns>
A pattern is a memorized, repeating, series of pan, tilt, zoom and preset functions that can be
recalled with a command from a controller or automatically by a programmed function (alarm,
park or power-up).
The Spectra III SE can handle up to four user-defined patterns. Pattern length is based upon
memory usage rather than a fixed amount of time. The complexity of a pattern will determine
the amount of storage available to program other patterns.
To program a pattern:
1. Use the joystick to position the cursor beside PATTERN NUMBER. Press Iris Open. The
cursor moves to the right.
2. Move the joystick up or down to view selections. Press Iris Open to enter selection.
3. Use the joystick to position the cursor beside PROGRAM PATTERN.
4. Press Iris Open. The Patterns programming window appears on the monitor.
5. Follow the directions displayed on the monitor.
After a pattern is programmed, the remaining storage percentage is displayed on the screen.
This is the amount of memory available to program the remaining patterns.
To clear a pattern:
1. Use the joystick to position the cursor beside CLEAR PATTERN.
2. Press Iris Open.
3. Follow the directions displayed on the monitor.
NOTE: When programming one or more presets within a pattern use the normal controller
commands to Call a Preset.
NOTE: Not all controllers can start all four patterns. However, any of the four patterns can be
automatically started with park, power-up, and alarm functions.
PATTERN NUMBER 1
<PROGRAM PATTERN>
<CLEAR PATTERN>
BACK
EXIT
REFERENCE INFORMATION
PATTERN USAGE 0%
REMAINING 100%
PATTERNS
BACK
EXIT
<CAMERA>
<MOTION>
<POWER UP>
<LINE SYNC>
<PRESETS>
<PATTERNS>
<ZONES>
<WINDOW BLANKING>
<ALARMS>
<AUX>
<ALERT>*
<CLEAR>
<PASSWORD>
DOME SETTINGS
EXIT
SPECTRA III
LANGUAGE ENGLISH
<SYSTEM INFORMATION>
<DISPLAY SETUP>
<DOME SETTINGS>
ACK ALERT*
RESET CAMERA
CYCLE CAMERA POWER
REBOOT SYSTEM
* This setting only applies to
Pressurized Spectra III SE dome
systems with software version
1.25 or higher.