Filter
Top Products
36 C2443M-C (1/04)
3. Select the alarm priority:
a. Use the joystick to position the cursor beside ALARM PRIORITY.
b. Press Iris Open. The cursor moves to the right.
c. Move the joystick up or down to view the available selections. Available settings
include HIGH, MEDIUM, and LOW (default). If multiple alarms with different priorities
are active at the same time, the dome will only go to the alarms with the highest
priority.
d. Press Iris Open to enter selection.
NOTE: HIGH - Alarm action takes highest priority and will override manual pan, tilt,
and zoom control.
MEDIUM/LOW - Alarm action will not occur if an alarm occurs during manual
pan, tilt, and zoom control.
4. Set the alarm action:
a. Use the joystick to position the cursor beside ALARM ACTION.
b. Press Iris Open. The cursor moves to the right.
c. Move the joystick up or down to view the available selections. The following are the
settings for alarm action:
NONE - No action when alarm is triggered.
PRESET - Dome goes to the preset that is the same as the alarm number. Preset
1 will go to Alarm 1.
PATTERN 1 - Dome runs pattern 1 when alarm is triggered.
PATTERN 2 - Dome runs pattern 2 when alarm is triggered.
PATTERN 3 - Dome runs pattern 3 when alarm is triggered.
PATTERN 4 - Dome runs pattern 4 when alarm is triggered.
AUTO SCAN - Dome starts auto scan operation when alarm is triggered.
RANDOM SCAN - Dome starts random scan operation when alarm is triggered.
FRAME SCAN - Dome starts frame scan operation when alarm is triggered.
d. Press Iris Open to enter selection.
BACK
EXIT
RESUME OFF
SEQUENCE (SECS) 5
RESET DELAY (SECS) 0
<ALARM SETTINGS>
ALARMS
EXIT
SPECTRA III
LANGUAGE ENGLISH
<SYSTEM INFORMATION>
<DISPLAY SETUP>
<DOME SETTINGS>
ACK ALERT*
RESET CAMERA
CYCLE CAMERA POWER
REBOOT SYSTEM
BACK
EXIT
<CAMERA>
<MOTION>
<POWER UP>
<LINE SYNC>
<PRESETS>
<PATTERNS>
<ZONES>
<WINDOW BLANKING>
<ALARMS>
<AUX>
<ALERT>*
<CLEAR>
<PASSWORD>
DOME SETTINGS
BACK
EXIT
ALARM NUMBER 1
ALARM PRIORITY LOW
ALARM ACTION NONE
ACTIVATE AUX NO
ALARM CONTACT N/O
ALARM SETTINGS
* This setting only applies to
Pressurized Spectra III SE dome
systems with software version
1.25 or higher.