Filter
Top Products
VIDEO
OUT
KEYBOARD
MONITOR
POWER OUT
COM
RX-
RX+
POWER IN
POWER OUT TO MONITOR
KBD300A INPUT
VIDEO OUT TO MONITOR
2 WIRE CONTROL, D OR P PROTOCOL
TIGHTEN SET SCREWS
TO SECURE ASSEMBLY
ON/OFF SWITCH
115 VAC
230 VAC
FUSE COVER
C3410M (2/06)
DEMOKIT-MINI/DEMOKIT-MINADPT
Spectra
®
Mini Demo Kit
Pelco World Headquarters • 3500 Pelco Way • Clovis, California 93612 USA • www.pelco.com
USA & Canada • Tel: 800/289-9100 • Fax: 800/289-9150
International • Tel: 1-559/292-1981 • Fax: 1-559/348-1120
®
NOTE: Demonstration unit only, no certification required.
IMPORTANT: This
product is factory
set to operate at
115 VAC. For 230 VAC
operation, move the switch to
the 230 VAC position before
applying power to the unit.
NOTE: Extra fuses are
supplied with the equipment.
To change the fuse, use a small
screwdriver and remove the
fuse cover.
The DEMOKIT-MINI and the DEMOKIT-MINADPT are designed for
demonstrating the Spectra Mini dome system.
The DEMOKIT-MINI is a complete kit and includes the following parts:
1 Base assembly
1 Tube
1 Head assembly
2 Power cords (1 USA standard and 1 European standard)
The DEMOKIT-MINADPT contains the head assembly only. It is
designed to adapt the Spectra III™/Spectra III SE demonstration kit for
use with the Spectra Mini dome system.
To assemble the demonstration kit:
1. Connect the electrical connector in the bottom of the tube to the
electrical connector in the base assembly. Place the tube on the
base assembly and tighten the set screws to secure the tube to the
base.
2. Connect the electrical connector in the head assembly to the
electrical connector in the top of the tube, and then fit the head
assembly onto the top of the tube. Tighten the set screws.
3. Connect the BNC connector and the RJ45-10 connector in the
head assembly to a Spectra Mini dome, and then attach the dome
system to the head assembly with the screws provided in the head
assembly.
4. Connect a monitor, KBD300A keyboard, and power (make sure the
voltage selection switch is in the proper position before applying
power to the unit). A terminal block is provided for daisy-chaining
equipment.