Filter
Top Products
Pelco Manual C480M-F (10/04) 5
Figure 2. CM8000 Corner Mount Installation
3.2 WALL/CEILING MOUNTING
To mount the enclosure to a wall or ceiling, follow the steps outlined below.
1. Remove the two (2) tamper-resistant screws and open the cover. A special
socket is provided (fits 1/4" square drive).
2. Using the enclosure or the template provided (see Figure 3), mark and drill
holes in the mounting surface.
3. Knock out any of the two (2) cable entry holes desired on the enclosure body.
4. Attach the enclosure with the required fasteners.
5. Route all cables through the appropriate knockouts.
3.3 CM8000 CORNER MOUNT INSTALLATION
Before installing the CM8000 corner mount to a wall, make certain that the mount-
ing surface is able to support the full load of the enclosure, mount, and all other
equipment such as camera, lens, etc.
To install the CM8000 and mount the enclosure, perform the following steps (see
Figure 2):
1. Position the CM8000 in the desired corner and use as a template for marking
the four (4) mounting holes. Mark the holes and drill.
2. Mount the CM8000 with the required fasteners (not supplied). Route the cables
into the mount.
3. Open the cover.
4. Knock out any of the two (2) cable entry holes desired on the enclosure body.
5. Route all cables through the appropriate knockouts.
6. Attach the enclosure to the CM8000 with the required fasteners.
Refer to Section 3.6, Electrical Connection, and Section 3.7, Camera/Lens Installa-
tion for further details.
NOTE:
The four (4) fasteners (mini-
mum 3/8" diameter recommended)
required to secure the CM8000 to a
wall, and the four (4) 5/16-18 fasten-
ers required to secure the enclosure
to the CM8000, are not supplied.