Filter
Top Products
C3432M-G (4/09) 37
Network not
working
Faulty cable
connection
Check all cable connections and ensure all plugs are
properly plugged in.
Incorrect serial device
configuration
A hub will not work with the available network
bandwidth shared across all ports. Use a Fast Ethernet
switch, Gigabit Ethernet switch, or a cable modem
router with an n-Port switch.
Network connectivity
issues
Contact your network administrator.
Unable to sync
to an Endura
®
system manager
or NTP server
after changing
networks
Network connectivity
issues
• Disconnect the power cable (either PoE or 24 VAC)
and then reconnect it to the camera. Power is
indicated by the LED. The LED will flash (green) five
times per second for approximately two minutes if
the camera has power.
• Reset the camera’s factory defaults (refer to Reset
Button on page 34).
Table F. Troubleshooting the IP110 Series (3 of 3)
Problem Possible Cause Suggested Remedy