Filter
Top Products
30 C3425M-E (1/09)
Service Connector
The IS90 Series Camclosure integrated camera system includes a service connector that outputs camera
video. Use it at the installation site to set up the field of view and to focus the camera.
Figure 20. Service Connector
Pelco offers two optional items (CST150 and ICS-SC) that plug directly into the service connector. Before
using either option, you must loosen the tamper-resistant screws to remove the trim ring from the back
box. Use a 1/8-inch hollow screwdriver bit (not supplied).
The optional CST150 has a 3-foot (0.9 m) cable and microdisplay for viewing camera video. Plug it into the
service connector and view the video.
NOTE: The three buttons on the CST150 are not used with the IS90 Series Camclosure.
The optional IS-SC is a 4-foot (1.2 m) cable with a service connector and a BNC connector. Plug the service
connector into the unit. Then connect the other end to any standard BNC (VIDEO IN) connector on a
monitor.
To assemble a longer service cable for the Camclosure integrated camera system, purchase the following
items from a local electronics supply store:
Qty Description
1 2.5 mm monaural headphone plug
1 CPM 88 miniature coaxial connector
1 RG174/U coaxial cable
SERVICE
CONNECTOR