Filter
Top Products
4 Pelco Manual C233M-G (8/95)
3.1.3 Mounting the Hanger Assembly
1. Determine the location for, and the type of mount to be used. Remember to
allow for adequate clearance on all sides of the monitor.
2. Use the adapter mount as a template to mark the required mounting holes.
3. Using the necessary fasteners, attach the adapter mount to the chosen sur-
face.
4. Thread the mounting pipe into the mount, stopping at the desired position,
after the threads have become tight (approximately 30 ft lb). (If the MRCA or
MRWA is being used, tighten the 8-32 screw in the pipe nut to lock the pipe
threads.)
3.1.4 Monitor Mounting
1. Set the monitor assembly into the mounted hanger assembly.
2. Align the threaded inserts in the monitor brackets with the slots in the pan
bracket.
3. Secure the monitor assembly to the hanger assembly with the #10 screws,
lockwasher, and flat washers supplied. (See Figure 2)
4. Tilt the monitor to the desired angle and tighten the 1/2-13 hex bolts.
5. Make all necessary electrical connections.
NOTE:
When determining the
mounting location, consideration
must be given to the total weight of
the monitor and the mount. The
mounting surface must be adequate
to support this weight.