Filter
Top Products
Pelco Manual C397M (4/98) 7
3.3 WIRING
1. Route the six-foot power/video/control cable through the wall or pedestal mount
if applicable.
2. Connect the end of the cable with the 16-pin connector to the mating connec-
tor in the base of the pan/tilt unit.
3. Connect the other end of the cable as follows:
a. Connect the coax cable to the video input of the controller.
b. For models PT7729WX, PT7729WX-1, PT7723WX-1 and PT7729WX-3,
connect the Wiretron control wires (refer to Figure 2).
c. For models PT7729RX-1/PP and PT7729RX-3/PP, connect the alarm
outputs (cable not supplied). Refer to Figure 2.
d. Plug the power cord into either 120 VAC or 230 VAC, depending on your
model.
Proceed to Section 3.4, TESTING SYSTEM AND ADJUSTING LIMIT STOPS.