Filter
Top Products
13
Getting Started
To use an outside power source
You can operate your camcorder using the
power from the wall outlet (wall socket) by
making the same connections as you do
when charging the battery pack. The battery
pack will not lose its charge in this case.
To remove the battery pack
1 Turn off the power, then press PUSH.
2 Remove the battery pack in the direction
of the arrow.
When storing the battery pack
Fully discharge the battery before storing it
for an extended period (p. 61).
To check the remaining battery
(Battery Info)
Set the POWER switch to OFF(CHG), then
press DISP/BATT INFO.
After a while, the approximate recordable
time and battery information appear for
about 7 seconds. You can view the battery
information for up to 20 seconds by
pressing DISP/BATT INFO again while the
information is displayed.
You can check the remaining battery charge
on the LCD screen.
Charging time
Approximate time (min.) required when
you fully charge a fully discharged battery
pack.
2
1
POWER switch
PUSH
Indicator Status
Sufficient power remaining
Battery low, recording/
playback will stop soon.
Replace the battery with a
fully charged one, or charge
the battery.
Battery pack Charging time
NP-FH30 (supplied) 115
NP-FH50 135
NP-FH70 170
NP-FH100 390
BATTERY INFO
BATTERY CHARGE LEVEL
REC TIME AVAILABLE
LCD SCREEN
VIEWFINDER
:
:
85
99
min
min
0% 50% 100%
Remaining battery (approx.)
Recording capacity (approx.)
Continued ,