Filter
Top Products
《95》
Starting PC mode
• If you connect the USB cable to a USB port on your PC and then turn on the power, the
camera will automatically switch to "computer connection mode".
• In this mode, you can download stored images to your PC through the USB cable.
• The LCD monitor is always turned off in PC mode.
• The camera status lamp will blink when the files are transferring via the USB connection.
■ Connecting the camera to a PC
1. Turn the PC power on.
2. Turn the camera power on.
3. In any mode other than Voice Recording mode, press
the MENU button.
4. Press the LEFT/ RIGHT button and select the [SETUP]
menu tab.
5. Select the [USB] menu by pressing the UP/ DOWN
button and press the RIGHT button.
6. Use the UP and DOWN buttons to select [COMPUTER], and then press the OK button.
7. Press the menu button twice and the menu will disappear.
8. Connect the PC and the camera via the USB cable.
- Insert the small plug of the USB cable into the camera USB connection terminal.
- Insert the large connector of the USB cable into the USB port of the PC.
- The plugs must be firmly inserted.
■ Disconnecting the camera and PC : Refer to page 98(Removing the removable disk).
※ If you selected [PRINTER] in Step 6, when
you connect the camera to your printer, the
[CONNECTING…] message will be
displayed on the LCD monitor and the
connection will not be established. In this
case, disconnect the USB cable, and then
follow the procedure from Step 3 and
onward.
● The camera driver must be installed before using PC mode.
INFORMATION
2048
◀▶
SETUP
IMPRINT
BEEP
USB
COMPUTER
PRINTER
BACK:
◀
SET:OK