Filter
Top Products
✤
✤
■
-
-
1.
2. (PLAY/STILL)
3.
■
■
■
■
■
■
Basic Recording
3434
ENGLISH
Adjusting the LCD during PLAY
✤ You can adjust the LCD during playback.
✤ The adjustment method is the same procedure as used in CAM
mode. (see page 31)
The Speaker works in PLAYER mode only.
■
When you use the LCD screen for playback, you can hear recorded
sound from the built-in Speaker.
- Follow the instructions below to decrease or mute
speaker volume in the PLAYER mode.
- Take the following steps to lower the volume or
mute the sound while playing a tape on the
camcorder.
1. Set the power switch to PLAYER mode.
2. Press (PLAY/STILL) to play the tape.
3. When you hear sounds once the tape is in play, use the
MENU SELECTOR to adjust the volume.
■
A volume level display will appear on the LCD.
Levels may be adjusted from anywhere between 00
to 19. You will not hear any sound when the volume
is set on 00.
■
If you close the LCD while playing,
you will not hear sound from the speaker.
Notes
■
When the cable is connected to the Multi AV jack,
you cannot hear sound from the speaker and cannot
adjust the volume.
■
If a cable is connected to the Multi AV jack, you can
hear sound from the speaker when AV IN/OUT MODE
on MENU is set to AV IN or S-VIDEO IN.
■
You can hear sound from speaker by removing the
connected cable from the Multi AV jack.
■
The speaker turns off when you use earphones.
Controlling Sound from the Speaker
0 : 2 3 : 4 7
5 5 min
1 0 : 0 0 A M
J A N . 10 , 2 0 0 3
VOL. [ 1 1 ]
<3-2>
VOLUME
2
3-1