Filter
Top Products
ENGLISH
90
Maintenance
After finishing a recording
✤ At the end of a recording, you must remove the power source.
✤ When recording with a Lithium Ion Battery Pack, leaving the pack on the camcorder can reduce the life span
of the battery. Hence, it should be removed.
After completing a recording session
1. Slide the TAPE EJECT switch in the direction of the arrow.
■ Opening the cassette door ejects the tape automatically.
■ Please wait while the tape is completely ejected.
2. After removing the tape, close the door and store the camcorder in a dust free
environment.
■ Dust and other foreign materials can cause square-shaped noise or jerky
images.
3. Set the power switch to the OFF mode.
4. Disconnect the power source or remove the Lithium Ion Battery Pack.
■ When disconnecting a power supply, remove it in reverse order, by referring to page 21.
■ Hold down the BATTERY RELEASE button and slide the battery pack in the direction of the arrow.
REV
S.SHOW
FWD
DELETE
MEM
MEM/P
1
3 4
2
OFF