Samsung VP-D23I Camcorder Accessories User Manual


 
101
101
ENGLISH
Troubleshooting
Before contacting a Samsung authorized service center, perform the
following simple checks.
They may save you the time and expense of an unnecessary call.
Self Diagnosis Display
Moisture Condensation
If the camcorder is brought directly from a cold place to a warm
place, moisture may condense inside the camcorder,
on the surface of the tape, or on the lens. In this condition, the tape
may stick to the head drum and be damaged or the unit may not
operate correctly.
To prevent possible damage under these circumstances, the camcorder
is fitted with a moisture sensor.
If there is moisture inside the camcorder, (DEW) is displayed. If
this happens, none of the functions except cassette ejection will work.
Open the cassette compartment and remove the battery.
Leave the camcorder for at least two hours in a dry warm room.
slow
slow
no
slow
slow
slow
slow
the battery pack is almost discharged. Change to a charged one.
When the remaining time on the tape is
about 2 minutes
Prepare a new one.
the tape reached its end.
Change to a new one.
there is no tape in camcorder.
Insert a tape.
the tape is record protected.
If you want to record, release the
protection.
moisture condensation has formed in the
camcorder.
see below.
the camcorder has some mechanical fault.
1. Eject the tape.
2. Set to OFF.
3. Detach the battery.
4. Reattach the battery.
* If unresolved contact your
local service representative.
TAPE END!
TAPE END!
TAPE!
PROTECTION!
....
D
L
C
R
Display
Blinking Informs that... Action
Troubleshooting
DEW
2 2
2
1.
2. OFF
3.
4.
*
TAPE END!
TAPE END!
TAPE!
PROTECTION!
....
D
L
C
R
...