Sanyo LNS-T32 Camera Lens User Manual


 
- 8 -
LENS
ATTACHMENT
Part No. (610 275 6029)
4
MOUNT THE LENS
Remove protective caps (front and back) on the optional lens.
Mount the lens on the lens attachment with 4 Screws.
Connect the lens motor lead connector to the socket on the lens attachment. (Motor Driven
Lens only.)
Grasp the Lens Lock Lever and turn it fully upward. Install the Lens into the projector. Turn
the Lens Lock Lever fully downward until lever is Locked (clicked position) properly.
When installing the Motor Driven Lens, be sure to mount Lens Motor on left-side.
After installing the lens, make sure the Lens is not loose and properly installed.
1.
2.
3.
4.
Push the Lens
Lock Lever fully
downward until it is
locked (clicked).
DRIVER
IN THE LENS
LENS
ATTACHMENT
SOCKET
CONNECTOR
LENS MOTOR
LEAD
LENS LOCK LEVER
LENS LOCK LEVER
SCREW
When the lens is attached to the projector and
images are being projected onto the screen, the
peripheral focus may be out of focus in some
localized areas. If this happens, insert the spacer
in between the lens attachment and the lens to
correct the focus.
Correcting the focus
Spacer "1"
Color; Clear
Thickness; 0.1 mm
40-inch projection
Screen
Inserting the spacers corrects the distance for best
diagonal focus at the screen.
The corrected distance is determined by the
thickness of the spacers that are used. As a guide,
the distance is adjusted by approximately 30 mm
for each 0.1-mm thickness of the spacers.
There are three types of spacers provided, and
there are four of each spacer type. Use these
spacers to correct the distance as required.
C
D
A
B
Distance
Spacer "2"
Color; Black
Thickness; 0.2 mm
Spacer "1"
Color; Cream
Thickness; 0.3 mm
Correction distance
30 mm/for 40-inch
projection
Correction distance
55 mm/for 40-inch
projection
Correction distance
80 mm/for 40-inch
projection
SPACER
A
B
C
D
A~D
Insertion position
of the focus
correction spacers.
Refer to following.
Insert spacers in
the location A~D
(above figure)
corresponding to
the screen location
A~D.
Screen