Sony 3-869-888-16 (1) Security Camera User Manual


 
94
Chapter 5 Settings
Notes
To perform the automatic detection again, click [Refresh].
A camera server (such as the SNT series) is detected as single camera
server, regardless of the number of cameras connected. When registering
multiple cameras, register them as different cameras based on their
connection channels.
2
Configure all settings including the IP address settings.
NSR Network Device
To display IP information for a network port, click [V] and then select the
network port from the list that appears.
Found Cameras List
Displays a list of detected cameras.
To update the contents of the list, click [Refresh]. All input values except
for user names and passwords of the camera administrators are overwritten
by the information obtained by the IP Setup protocol.
Camera names that are already registered on the NSR appear. Furthermore,
if a host name is specified for “Address” in the “Main” settings of the
“Camera” screen for a camera already registered on the NSR, the IP address
is determined from the DNS, compared with detected camera IP addresses,
and then a judgment is made.
Check
Select the check boxes of the cameras for which you want to set the
IP addresses. To select all the check boxes, click [Select All].
Also select the registered cameras for which you want to change IP
addresses.
#
Sequential numbers are assigned to the cameras in the order of
detection. These numbers are added only for display purposes and
are not for indicating anything like priority order.
Network
Displays the network device number of the NSR.