Filter
Top Products
97
Chapter 5 Settings
Detecting Cameras on the Network Automatically and Registering Multiple
Cameras
Detect cameras automatically and then register them with IP addresses to the
NSR. You can specify camera names, as well as the user name and password of
the camera administrator.
After detecting cameras automatically, switch to the [Camera IP Setup] screen
if you want to set camera IP addresses prior to registration. For details, see
“Setting IP Addresses after Detecting Cameras Automatically (Camera IP
Setup)” (page 93).
1
Display the “Camera” screen and then click [Register Cameras] at the top
of the window.
Cameras are detected automatically and the “Register Multiple Cameras”
screen appears.
A list of detected cameras is displayed in the “Register Multiple Cameras”
screen. The results are displayed for all network devices of the NSR.
Note
To perform the automatic detection again, click [Refresh].
2
Configure all the settings.
Found Cameras List
Displays a list of detected cameras.
To update the contents of the list, click [Refresh]. All input values except
for user names and passwords of the camera administrators are overwritten
by the information obtained by the IP Setup protocol.
Cameras already registered on the NSR are not displayed. Furthermore, if a
host name is specified for “Address” in the “Main” settings of the “Camera”