Filter
Top Products
125
Transferring Data between the Switcher and a Computer
Chapter 6 Control Using External Devices
Transferring Data between the Switcher and a
Computer
Connecting a computer to the LAN connector on the Processor Unit allows you
to save the data set on the switcher on the computer (download) or import the
data from a computer (upload) to the switcher.
The following data can be downloaded or uploaded:
• Frame memory image data (FM1 and FM2)
• Setting data (camera position data, snapshot data, and SETUP menu data)
Connection and Configuration
Connecting a computer
Connect the LAN connector on the switcher to the LAN connector on a
computer with a cross cable (not supplied).
For the connection, see “Connecting a Computer for Storing the Setting Data”
on page 38.
Setting up the switcher
Display menu page 963 to set up the IP address and network mask of the
switcher and to set “FTP” to “Enable.”
Example of the IP address: 192.168.1.1
Example of the network mask: 255.255.255.0
For details on the setup, see “Setting Up the Switcher for Connecting the
Computer (Menu Page 963)” on page 60.
The switcher may not function temporarily when a LAN cable is plugged or
unplugged, or while uploading or downloading is being executed between the
switcher and a computer. Set “FTP” to “Disable” when you are not
communicating with a computer.
Downloading/Uploading
1
If the computer is using a proxy server to access an Internet, set it to “Access
the Internet without using a proxy server.”
2
Set up the TCP/IPv4 IP address of the computer.
Example of IP address: 192.168.1.101
3
Set up the same network mask as that of the switcher for the TCP/IPv4
network mask of the computer.
Example of the network mask: 255.255.255.0
UTILITY IPADD NET MASK FTP APPLY 3/3
LAN
1. 1 255. 0 Enable
Exec
963
Note