Filter
Top Products
23
Control Panel
Chapter 2 Locations and Functions of Parts
e CLEAR button
x When menu mode is selected
When this button is pressed, the last two digits of the menu
page reset to “00.”
x When CAM mode is selected
When this button is pressed, the camera position number
displayed on the display panel disappears.
x When SW mode is selected
When this button is pressed, the snapshot, direct wipe, or
direct PIP number displayed on the display panel
disappears.
f Numeric buttons 0 to 9 and . (dot) button
x When menu mode is selected
Use the numeric buttons and . (dot) button to enter menu
page.
For procedures for menu page input, see “To display the
menu” on page 22.
x When CAM mode is selected
Use numeric buttons 0 to 9 to enter the camera position
number.
x When SW mode is selected
Use numeric buttons 0 to 9 to enter the snapshot, direct
wipe, or direct PIP number.
To enter the two-digit number, press the second-digit
number then the first-digit number.
To correct a number entered, press the CLEAR button then
enter the correct number.
6 Display Panel / Camera/Switcher/Menu Control Section
The buttons and controls in this section differ in function
depending on whether the switcher is in CAM mode, in
SW mode or in menu mode.
a Display panel
Displays the menu, the current effect, and the camera
settings.
While viewing the display panel, you can check and
change the settings.
When the menu of a lower layer has further lower layers,
the menu name is followed by “..”
The following display panel shows a representative
example:
Menu layers in menu mode
Note
NEAR FAR
EXIT
PAG E
FOCUS BRIGHT ZOOM PAN/TILT
F1 F2 F3 F4
1 Display panel
2 Adjustment controls
3 EXIT button
4 PAGE button
SETUP
INPUT
NAME..
FS..
ASSIGH..
SIDE..
ADJUST.. 1/1
920
PROC..
Higher menu layer
Current displayed menu layer
Lower menu layer Page number
Menu page
INPUT
ADJUST
XPT BTN
3
Y-LEVEL
1.00
SETUP
0.0
3/6
923
C-LEVEL
1.00
Current displayed
menu layer
Menu pageSetting values
Higher menu layer Setting items Page number