Sony HSR-2 Security Camera User Manual


 
Chapter 5 Connections and Preparations
Chapter 5 Connections and Preparations 5-15
Setting Passwords
You can set passwords to release the key-lock function
that is activated by pressing the LOCK key.
As you can classify the recorder’s key functions for
three levels each having a different password to release
the locks, operations of the functions can be limited by
the levels, such as Level 1 for the operator, Level 2 for
the administrator, and Level 3 for the system manager.
For the level settings, use FUNCTION LEVEL SET of
the Function Control Menu (page 4-11).
Then, set the passwords using PASSWORD SET of
the same menu.
To set a new password
1 Highlight FUNCTION CONTROL MENU (or
display FuncMenu) of the top menu by pressing
the V or v key, then press the b key.
The Function Control menu is displayed.
SETUP MENU
FUNCTION CONTROL MENU
AUTO REW : ON
POWER ON REC : OFF
BEEP : ON
STILL : FRAME
PRIORITY
1)
: PLAY
PRE REV TIME
1)
: 5 MIN
FUNCTION LEVEL SET
PASSWORD SET
2 Highlight PASSWORD SET (or display Password)
by pressing the v key, then press the b key.
The menu shifts to password setting.
SETUP MENU
FUNCTION CONTROL MENU
PASSWORD SET
M LEVEL 1 m
LEVEL 2
LEVEL 3
3 Highlight the level for which a password is to be
set, then press the b key.
The password setting display for the selected level
appears.
PASSWORD
INPUT NEW PASSWORD
– – – –
SHIFT : M
INPUT: NUM KEY
TO MENU : MENU KEY
DATA SET: SET KEY
CLEAR : RESET KEY
4 Enter a 4-digit number from the left digit by using
the numeric keys.
To enter 0, press 0.
The display for the entered digit changes to
*
both
on the monitor display and character display.
The B key acts as a backspace key.
5 Press the SET key.
A request message for repeated input of the same
password appears, and the number input area
returns to “– – – –.”
6 Enter the same number again and press the SET
key.
A message “NOW SAVING” is displayed, and the
password is stored in nonvolatile memory.
Repeat steps 2 to 6 for each of the levels as required.
To change or delete the password
1 Call the password setting display by performing
step 1 and 3 of “To set a new password.”
A message requesting the password appears, and
the input area “– – – –” appears.
2 Enter the password currently set using the numeric
keys and press the SET key.
The recorder enters the status in step 3 of “To set a
new password.”
1) HSR-2/2P only
(Continued)