Filter
Top Products
14 (GB)
Rear Panel
5 VIDEO connectors (BNC type)
IN: Connect a video camera. When using a
multiplexer, connect the video output connector of
the multiplexer to this input.
LOOP OUT: The signal supplied to the IN connector
is output as-is. The signal is output even when the
power to the HSR-X200/X200P is off.
OUT: Connect to the VIDEO IN connector of a
playback monitor. A composite video signal will
be supplied. Character signals are superimposed
on the output video signal. When the video signal
is to be monitored via a multiplexer, connect to the
video input connector of the multiplexer.
6 RS-232C connector (D-sub 9-pin)
An external controller, such as a PC, can be connected.
7 -AC IN connector
Connect AC power using the supplied AC power cord.
8 Power cord holder
Secure the AC power cord using the supplied tie, as
shown below.
1 PC CARD slot
For PC cards of Type 2.
Insert a commercially available SCSI PC card to
enable data backup using a DDS tape drive. If you
insert a commercially available LAN PC card, network
control will be enabled.
2 MIC (microphone) connector (monaural
minijack)
Connect a microphone for audio recording.
3 AUDIO connectors (phono jacks)
IN: Connect an audio signal.
OUT: Connect to the AUDIO IN connector of a
monitor.
4 S-VIDEO connectors (Mini DIN 4-pin)
IN: Connect a Y/C-separated S-VIDEO signal.
LOOP OUT: The signal supplied to the IN connector
is output as-is. The signal is output even when the
power to the HSR-X200/X200P is off.
OUT: A Y/C-separated S-VIDEO signal will be
supplied. Connect to the S-VIDEO input of a
playback monitor. When the S-VIDEO signal is to
be monitored via a multiplexer, connect to the
S-VIDEO input of the multiplexer.
Locations and Functions of Parts
PC CARD
MIC
AUDIO
IN
IN
OUT
OUTLOOP OUT IN OUTLOOP OUT
RS-232C
IN INOUT OUT
WARNING OUT
CLOCK
NON REC OUT
ALARM
RESET
FULL
ALARM
FULL
ON
RS485
TERMINATE
OFF
-AC IN
COMCOM
AB
INOUTCOM COMCOMCOM COM
REMOTE
RS485
SERIES
SW OUT
S-VIDEO VIDEO
qa All Reset button
1 PC CARD slot
2 MIC connector
3 AUDIO connectors
4 S-VIDEO connectors
5 VIDEO connectors 6 RS-232C connector
7 -AC IN connector
8 Power cord holder
9 Alarm terminals
0 Control terminals
Tie