Filter
Top Products
Since the shutter speed becomes slow and the camera-shake tends to occur more easily, it
is recommended that you use a tripod.
The longer the exposure time, the more noise will be visible on the image.
After shooting, noise reduction will be done for the same amount of time that the shutter was
open. However, you cannot shoot any more while noise reduction is in progress.
You cannot set the shutter speed to [BULB] in the following situations:
When the [Smile Shutter] function is activated.
When the [Auto HDR] function is activated.
When [Picture Effect] is set to [HDR Painting] or [Rich-tone Mono.].
When the [Multi Frame NR] function is activated.
When the [Drive Mode] function is set to [Cont. Shooting], [Spd Priority Cont.] or [Self-timer(Cont)].
If you use the above functions when the shutter speed is set to [BULB], the shutter speed is
temporarily set to 30 seconds.
Hint
Images shot in [BULB] mode tend to blur. We recommend that you use a tripod or a multi-
terminal-compatible remote commander that has a shutter button lock function (sold
separately).
[29] How to Use
Shooting Selecting a shooting mode
Memory recall
Allows you to shoot an image after recalling often-used modes or camera settings registered in
advance.
1. Set the mode dial to MR (Memory recall).
2. Press the left/right side of the control wheel or turn the control wheel to select the desired
number, then press on the center.
You can also recall registered modes or settings by selecting MENU → (Camera
Settings) → [Memory recall].
Note
Register shooting settings in advance by [Memory].
If you set [Memory recall] after completing the shooting settings, the registered settings are
given priority and the original settings may become invalid. Check the indicators on the
screen before shooting.