Filter
Top Products
4-4 (E)
HDC-900/950 IMM
4-4. Registering the Scene File
4-4. Registering the Scene File
The scene file is used for storing temporary video adjustment values according to the scene. 5 files can be
stored and the data will be stored in the camera and memory stick. The data can be stored using a setting
menu or MSU (master setup unit).
Scene files can be copied between cameras using the memory stick.
As for the items to be stored, refer to Section 4-8,“ File Items”.
m
. Scene files are files for storing the differences from the reference file. Therefore when the reference file
is changed, output of the scene file item corresponding with the item changed in the reference file is
also changed.
. As for the setup menu, refer to Section 3.
. Before storing the file in the memory stick, make sure that the LOCK switch on the memory stick is in
OFF position.
Storing Using Setup Menu (Refer to step 1 of Fig.4-3.)
(1) Set the setup menu as follows.
[PAINT] → [SCENE|FILE] → [STANDARD]
(2) Change the scene file item to the desired value.
(3) Set the setup menu as follows.
[PAINT] → [SCENE|FILE] → [STORE]
Select the scene file number to be stored.
Calling Using Setup Menu and Clearing the Call (Refer to step 2 of Fig.4-3.)
Select the scene file number called at the “SCENE FILE” page of the PAINT menu. A file currently being
called is shown with its file No. highlighted. Selecting the number again clears the call and resets the state
before calling.
Storing with MSU (Refer to step 1 of Fig.4-3.)
(1) Change the scene file item to the desired value.
(2) Press “STORE” of the scene file, and press the STORE number.
Calling with MSU and Clearing the Call (Refer to step 2 of Fig.4-3.)
Press the No. switch of the “SCENE FILE” to call. The switch also lights up. Press again to cancel the
call and turn off the switch.