Filter
Top Products
TOSHIBA
33
Display Screens (cont'd)
Data Setting Screens
The 'Data Setting Screens' sequentially display the data variables that can be set. Each variable is
displayed as the 'down' arrow key is pressed. The 'up' arrow can also be pressed at any time to back up
to the previous screen:
KEYS LOCK:DIS
TO CHANGE:SELECT
## / ## / ###(##)
TO CHANGE: SELECT
TIME ##:##:##
TO CHANGE:SELECT
BUZZER VOLUME: 2
TO CHANGE:SELECT
LCD SLEEP: 3MIN
TO CHANGE:SELECT
AUTO RUN: NO
TO CHANGE:SELECT
AUTO RETRAN: YES
TO CHANGE:SELECT
REMOTE:BYPASS
TO CHANGE:SELECT
COMM MODE: RS232
TO CHANGE:SELECT
BAUD RATE: 1200
TO CHANGE:SELECT
INI BAT TST: YES
TO CHANGE:SELECT
AUTO BATT TST: NO
TO CHANGE:SELECT
BATTERY TEST
DATA SET: SELECT
PERFORM BAT TEST
PUSH SELECT
VOLTAGE ADJ: +0
TO CHANGE:SELECT
CLEAR TIMER SET
See Notes 1,2
See Notes 1,2
See Notes 1,2
See Notes 1,2
See Notes 1,2
See Notes 1,2
See Notes 1,2
See Notes 1,2
See Notes 1,2
See Notes 1,2
See Notes 1,2
See Notes 1,2, 3
See Notes 1,2
See Notes 1,2
See Notes 1,2
See Notes 1,2
See Notes 1,2
DEFAULT SETTINGS
PUSH: SELECT
Notes:
1) If the key is pressed from any of the
Data Setting Screens then the return is to the
UPS Operation screen in the UPS Start-up
Screens (See page 29).
2) For explanations on changing each of these
settings when the key is pressed
(See pages 33 - 37).
3) When the automatic battery test mode has
been set to YES then the following screen is
displayed when scrolling through the data
setting screens:
NOTE: The data variables shown for each
screen indicate the default data set at the factory
(unless previously changed by the user).
Set
Monito
r
Shift
Select
INTERVAL: 10DAY
TO CHANGE: SELECT
See notes 1,2