Filter
Top Products
D4134844A
RESTRICTION FOR USE
1. Avoid irregular signal interface.
Do not attempt irregular signal interface other than specified. Under signal interface
other than recommended/specified in this instruction manual, the device might fail to
exert the maximum performance. In much worse case, if you continue to use your device
under incorrect signal interface, part(s) of inner circuits might burn down.
DISCLAIMER (LIMITED WARRANTY)
We disclaim any responsibility and shall be held harmless for damages or losses incurred by user(s) in
either of the following cases.
1.
In case damages or losses are caused by fire, earthquake, or other acts of Gods, the act by third party,
misuse by the user deliberately or erroneously, use under extreme operating conditions.
2. In case any indirect, additional, consequential damages (loss of expected interest, suspension of
business activities) are incurred as results of malfunction or non-function of this device, we shall be
exempted from assuming responsibility for such damages.
3. In case damages or losses are caused by incorrect use which is not in line with the instructions given in
this instruction manual.
4.In case damages or losses are caused by malfunction resulting from bad connection with other
equipment.
5.In case damages or losses are caused by repair or modification done by the user.
OTHER INSTRUCTIONS
Do NOT use power other than specified
Be sure to use DC12V power supply. The camera is designed to work only under the specified voltage.
Do NOT attempt to drive the camera with the power other than DC12V. Operating the camera under
power other than DC12V invites a fire or an electric shock hazard.
Avoid intensive light
Do NOT expose the camera’s image-pickup-plane to sunlight or other intense light directly. If the part of
CCD is exposed to spot-intensive light, you might get a picture problem like blooming and/or smear. You
might observe vertical stripes on your monitor if your camera is exposed to sunlight (or any other
intensive light), however, this is not a malfunction. Redirect your CH (camera-head) to different
directions in such case.
Use under right operation condition
This equipment is designed and guaranteed to work under the temperature range of 0 to 40 degrees C and
30 through 90% humidity range. Avoid using the equipment beyond that limits.
Handle with care
Take care not to drop the equipment, nor give strong impact, as this may cause breakdown.
Do NOT tamper with switches
Read this operation guide thoroughly before you touch switches and adjusters on the rear panel. Do
NEVER attempt to disassemble the camera and/or tamper with any inner switches, potentiometers, etc.