Toshiba CS4000BC Series Security Camera User Manual


 
6
D4134844A
CLOCK
Output level 2.0±0.3V(p-p)(on no-load condition)
Frequency
(EIA) 14.31818MHz±100ppm(on no-load condition)
(CCIR ) 14.18750MHz±100ppm(on no-load condition)
WEN On operate random shutter mode, WEN put out from
the fall time of VD to the fall time of VD under put
out video signal..
Polarity Positive
Diagram The circuit is shown in the figure below
(21) Electronic shutter Shutter speed can set by front panel switch As follow:
OFF,1/125,1/250,1/500,1/1000,1/2000,
1/4000,1/10000, F.L
1FLD,2FLD,4FLD,6FLD,8FLD,10FLD
(slow speed shutter mode)
(22) Random shutter RTS mode selection available
Mode1
Shutter-speed switch setting
Internal sync SYNC non-reset
Mode2
Shutter-speed switch setting
Internal sync SYNC non-reset
Mode3
Shutter-speed switch setting
Internal sync SYNC Reset
Mode4
Shutter-speed switch setting
Internal sync SYNC Reset
Mode5
Shutter-speed switch setting
Series
HD,
Series
VD
input
SYNC non-reset
Mode6
Shutter-speed switch setting
Series
HD,
Series
VD
input
SYNC non-reset
Mode7
Shutter-speed switch setting
Series
HD,
One-pulse
VD
input
SYNC non-reset
Mode8
Shutter-speed switch setting
Series
HD,
One-pulse
VD
input
SYNC non-reset
(23) Special shutter User-defined shutter-speed cued and timed by shutter
trigger and restart / reset pulse input ON /OFF
selectable via rear panel DIP SW.
(Initial factory setting :OFF)
(24) Restart Reset Restart Reset function available via rear DIP SW selection.
(25) Lens Mount Special Mount, by each head specification.
(26) Mass Camera control unit: about 350g
(27) GND Circuit GND---Chassis: Electrically continuous
(28) EMI Conforms to EN50081-2
WEN
2SC4176
51
10k
4700