Toshiba IK-65WDA Digital Camera User Manual


 
8
5.4 Back focus adjustment:
Back focus is adjusted at the factory to accom-
modate most standard lenses. If a slight adjust-
ment is needed, mount the lens to the camera
first. Then loosen the Focus Lock Screw. Rotate
the Focus ring until a clear image is achieved.
Retighten the Focus Lock Screw.
NOTE
When the lens weight is more than 2.2 lbs., support the camera on the lens
side rather than relying on the tripod mount of the camera.
5.5 Lens
This camera supports DC (direct drive) type of
auto-iris lens:
Connect the auto-iris connector plug to the IRIS
terminal on the side of the camera. Refer to the
cart below for correct wiring and set up.
Change the IRIS switch (DIP SWITCH SETTINGS
on rear panel) to select DC.
Direct Drive
IRIS Lens
1. Damp-(y)
2. Damp+(r)
3. Driver+(wh)
4. Driver-(g)
IRIS
terminal
pin