Filter
Top Products
- 19 -
6.8.2 PROPORTIONAL P/T
Proportional P/T controls the pan and tilt speeds according to the amount of zoom.
At telephoto settings, the pan and tilt speeds will be slower to keep the image from moving too fast
on the monitor.
Menu
<CAMERA SETUP>
<PAN/TILT SETUP>
<PRESET TITLES>
<OTHERS>
EXIT
MAIN MENU PAN/TILT MENU
AUTO FLIP ON
PROPORTIONALP/T ON
SCAN LIMIT STOPS OFF
MANUAL LIMIT STOPS OFF
PARK TIME MIN 0MIN
AUTO PATRO L P1 OFF
SCAN SPEED 5DEG./S
SCAN TILT ANGLE 30DEG.
STOP TIME 10SEC
MAX SPEED 400DEG/S
To enable PROPORTIONAL P/T:
1. Enter the preset command to access the main menu.
Refer to section 6.1 for the controller model and preset command.
2. Position the cursor ( ) next to PAN/TILT SETUP and press the OPEN button to access the Pan/
Tilt menu.
3. Position the cursor next to PROPORTIONAL P/T and press the OPEN button to move the
cursor to the right.
4. Move the joystick up or down to select ON or OFF.
5. To accept the selection, press the OPEN button or to cancel the selection, press the CLOSE
button.
6.8.3 SCAN LIMIT STOPS
When a Scan Limit Stop is reached during random, frame or auto scan, the dome camera will
reverse direction. A Left Scan Limit Stop and Right Scan Limit Stop can be set. The limit stops
must be greater than 10 degrees apart.
Menu
<CAMERA SETUP>
<PAN/TILT SETUP>
<PRESET TITLES>
<OTHERS>
EXIT
MAIN MENU PAN/TILT MENU
AUTO FLIP ON
PROPORTIONALP/T ON
SCAN LIMIT STOPS OFF
MANUAL LIMIT STOPS OFF
PARK TIME MIN 0MIN
AUTO PATRO L P1 OFF
SCAN SPEED 5DEG./S
SCAN TILT ANGLE 30DEG.
STOP TIME 10SEC
MAX SPEED 400DEG/S