Filter
Top Products
- 20 -
To enable SCAN LIMIT STOPS:
1. Enter the preset command to access the main menu.
Refer to section 6.1 for the controller model and preset command.
2. Position the cursor ( ) next to PAN/TILT SETUP and press the OPEN button to access the Pan/
Tilt menu.
3. Position the cursor next to SCAN LIMIT STOPS and press the OPEN button to move the cursor
to the right.
4. Move the joystick up or down to select ON or OFF.
5. To accept the selection, press the OPEN button or to cancel the selection, press the CLOSE
button.
To set SCAN LIMIT STOPS:
1. Set SCAN LIMIT STOPS to ON and exit menu.
2. Position the camera for the LEFT LIMIT STOP.
3. Enter 92 preset. SCAN LEFT LIMIT will be displayed on screen.
4. Position the camera for the RIGHT LIMIT STOP. If the right limit stop is less than 10 degrees
from the left limit stop, NOT ACCEPT will be displayed on screen,
5. Enter 93 preset. SCAN RIGHT LIMIT will be displayed on screen.
6.8.4 MANUAL LIMIT STOPS
When a Manual Limit Stop is reached during a manual (joystick) pan, the camera will stop. A Left
Manual Limit Stop and Right Manual Limit Stop can be set. The limit stops must be greater than 10
degrees apart.
Menu
<CAMERA SETUP>
<PAN/TILT SETUP>
<PRESET TITLES>
<OTHERS>
EXIT
MAIN MENU PAN/TILT MENU
AUTO FLIP ON
PROPORTIONALP/T ON
SCAN LIMIT STOPS OFF
MANUAL LIMIT STOPS OFF
PARK TIME MIN 0MIN
AUTO PATRO L P1 OFF
SCAN SPEED 5DEG./S
SCAN TILT ANGLE 30DEG.
STOP TIME 10SEC
MAX SPEED 400DEG/S
To enable MANUAL LIMIT STOPS:
1. Enter the preset command to access the main menu.
Refer to section 6.1 for the controller model and preset command.
2. Position the cursor ( ) next to PAN/TILT SETUP and press the OPEN button to access the Pan/
Tilt menu.
3. Position the cursor next to MANUAL LIMIT STOPS and press the OPEN button to move the
cursor to the right.
4. Move the joystick up or down to select ON or OFF.
5. To accept the selection, press the OPEN button or to cancel the selection, press the CLOSE
button.
To set MANUAL LIMIT STOPS:
1. Set MANUAL LIMIT STOPS to ON and exit menu.
2. Position the camera for the LEFT LIMIT STOP.
3. Enter 90 preset. MANUAL LEFT LIMIT will be displayed on screen.